We continue the exercise with the application of pyramids and a wall by performing
the following steps:
1. Open the drawing saved in
exercise 5.3
or A3D_05_04.DWG.
2. On top of one of the towers, apply the PYRAMID command, the
Edge
option,
and specifying two side corners with the height 15.
3. Copy the pyramid to the other tower.
4. Finally, we are going to build a small wall on the top of the largest box. We
apply the POLYSOLID command, change height to 1.2 units, width to 0.2
units, and
justify
it to the
right. Then we specify the points counter clockwise
5. Save the drawing with the name A3D_05_04FINAL.DWG.