Use the general shaft layout given and determine the critical diameters of the shaft based on infinite fatigue life with a design factor of 1.5. Check for yielding. Check the slopes at the bearings...

Extracted text: Use the general shaft layout given and determine the critical diameters of the shaft based on infinite fatigue life with a design factor of 1.5. Check for yielding. Check the slopes at the bearings for satisfaction of the recommended limits in Table 7-2. Assume that the deflections for the pulleys are not likely to be critical. The material selected is 1050 Q and T. Given: Sut = 163 kpsi and Sy = 117 kpsi. Use the following shaft layout assuming a gear transmits torque through a key and keyseat at location A to another gear at location B. 16 in 14 in F3 9 in Gear A 20-in dia. Gear B 8-in dia. FA 300 lbf 20 A) Determine the location of the critical section on the shaft. B) If the shaft's loading is fully reversed and the torque between points A and B is constant, what are the values of the mean and alternating torques and the mean and alternating moments in lbf-in?