predicted values portion for circuit A (series circuit), using a source voltage of 3.05 V and an R1 = 49 ohms and R2 = 99.5 ohms 2 / 4 Circuit A - Series Circuit 1. Label one resistor as RI and the...

Predict value for circuit A ( series circuit) Voltage = 3.05 R1= 49 R2= 99.5


Extracted text: predicted values portion for circuit A (series circuit), using a source voltage of 3.05 V and an R1 = 49 ohms and R2 = 99.5 ohms 2 / 4 Circuit A - Series Circuit 1. Label one resistor as RI and the other resistor as R2. Use the DMM to measure the actual resistance of each designated resistor. Record these values in Table 1 below. 2. Using the conductors and resistors, construct the series circuit as shown in the drawing, and connect the circuit to the DC power source. With the circuit energized (connected to the power supply), measure the source voltage (voltage across the terminals of the power supply). Record this value in the Table 1 below. Deenergize the circuit. 3. R2 Table 1 - Resistance and Source Voltage Measurements RI (2) R2 (2) Es (Volts) 4. Using your measured circuit values (Table 1), work as a group to calculate the unknown circuit values to complete Table 2 below. These calculations should be made and recorded before you make any additional circuit measurements. Record each calculated value in the appropriate cell of the "Calculated Value" column. Table 2 - Series Circuit Predicted and Measured Values Circuit value Calculated Values Measured Values Ea across RI Volts Volts Ea across R2 Volts Volts I through R1 Amps Amps I through R2 Amps Amps I total circuit Amps Amps R total Ω Ω