Please Fill In the blanks where I have marked red X's using the questions and Image below. 1. On the drawing above, before any geometric controls are applied, what is the coaxility tolerance is...

Please Fill In the blanks where I have marked red X's using the questions and Image below.

1. On the drawing above, before any geometric controls are applied, what is the coaxility tolerance is implied between the diameters?

2. On the part above, apply datum feature symbols to create a datum axis A-B by using the right and left diamters.

3. Apply a position coaxility between the right and left diamter of 0.1 at MMC.

4. Apply a position tolerance to the large center diameter within a diameter of 0.3 in relation to the single datum axis established by both datum features A and B.

Extracted text: Workshop Exercise 14.1 iv2 to bseleni noitlao9 15.3 15.1 alo L00.3 A-B Ø6.40 9.55 9.50 6.35 のX ×