// initialize the library by associating any needed LCD interface pin // with the arduino pin number it is connected to const int rs = 12, en = 11, d4 = 5, d5 = 4, de = 3, d7 = 2; LiquidCrystal lcd...

2); lcd.print ("high voltage"); "/>
Extracted text: // initialize the library by associating any needed LCD interface pin // with the arduino pin number it is connected to const int rs = 12, en = 11, d4 = 5, d5 = 4, de = 3, d7 = 2; LiquidCrystal lcd (rs, en, d4, d5, de, d7); void setup () { // set up the LCD's number of columns and rows: lcd.begin (16, 2); Serial.begin (9600); } void loop() { int sensorValue = analogRead (A0); float voltage = sensorValue * // print out the value you read: Serial.println (voltage); (5.0 / 1023.0); // print the number of seconds since reset: if (sensorValue < 2);="" lcd.print="" ("low="" voltage");="" if="" (2="">< sensorvalue="">< 4);="" lcd.print="" ("nominal="" voltage");="" if="" (sensorvalue=""> 2); lcd.print ("high voltage");