Lab #1: Deploy SOHO Network with NAT using Packet Tracer Software. [20%]This Lab relates to the following Course Learning Requirements: CLR 3: Properly apply subnet masks and addresses (IPv4 and...

Im using Cisco Packet Tracer and have no knowledge of how to go about doing this so steps would be greatly appreciated in the solution.


Lab #1: Deploy SOHO Network with NAT using Packet Tracer Software. [20%] This Lab relates to the following Course Learning Requirements: CLR 3: Properly apply subnet masks and addresses (IPv4 and IPv6) to devices in a network CLR4: Build a simple Ethernet, IPv4 and IPv6 networks using routers and switches Objective of this Lab: The objective of this lab to is evaluate your understanding of DHCP, DNS, IP addressing, Subnetting, Routing and NATing. It will also have you apply the skills learned in this course in a hands-on experience for network simulation using packet tracer. Pre-Lab Instructions: 1. To prepare you for this lab, read and understand modules 4, 5, 7, 11 and 12 content. 2. It is important that you understand how DNS and DHCP works, IP address classes including public and private IP address. 3. Understand different types of NAT and their configuration command. 4. Build topology and practice configuration on packet tracer. You will perform/configure this lab using Packet Tracer. If you require a refresher on how to use and save content in Packet Tracer, please revisit the content from modules 11 and 12. Lab Scenario: Q1. You are given a network 192.168.10.0/27 for your office. Your company should have one DHCP server and one DNS server with static IP address. You have 25 employees at your office and everyone is using a PC. DHCP server will provide IP address dynamically to these PCs. Your DNS should resolve www.myDNS.com for your employees. There is a Server 10.10.10.10/8 in another network. When your employees are accessing this server, they should use Public IP addresses so that your private network remains hidden from the outside world. For this purpose, your company already bought an IP pool range 200.10.0.1 - 200.10.0.99. Now implement NAT on the required router. (For designing topology you can show only 5 PCs in the office network) a) Once you are done with configuration, save the configuration by typing “wr” command on each router. Save the packet tracer file. b) Your packet tracer file should include all the required configuration on PCs, R1, R2, DHCP server, DNS server and Server on other network. [To check all the configuration in router, you can use the following command “show running-configuration”] Rubric and Marking Static IP for DHCP – 1 mark Static IP for DNS – 1 mark Static IP for server on other network – 1 mark Dynamic IP for hosts from DHCP – 2 marks DNS entry for www.myDNS.com – 2 marks IP route command on R1 and R2 for network reachability – 3 marks Dynamic NAT configuration on R1 – 10 marks 1 LAB.pkt