Create a minimum 2-page training module for junior network engineers that contains step-by-step instructions on installing and configuring Syslog, NTP and NAT. The paper should include both details...

1 answer below »

Create a minimum 2-page training module for junior network engineers that contains step-by-step instructions on installing and configuring Syslog, NTP and NAT. The paper should include both details and screenshots that serve as examples of what the junior network engineer will be seeing as they perform the training module. All writing should conform to current APA formatting rules with double spacing, indents to paragraphs and references.


Write a minimum 1-page paper on how best to use ftp/tftp, SNMP, and QoS to improve business continuity and disaster recovery including tools, personnel, training needed, etc.



Answered Same DaySep 06, 2022

Answer To: Create a minimum 2-page training module for junior network engineers that contains step-by-step...

Aditi answered on Sep 07 2022
75 Votes
SOLUTION
You may use Syslog Server to centrally gather all of the logs, and then you can utilise these logs to troubleshoot the devices. For the purpose of demonstrating how to set up Syslog Server with Cisco Packet Tracer,
we will use the following architecture.
Compare several options for health insurance
Find the health insurance that suits you the most.
Adjust the settings for the Syslog Server with Cisco Packet Tracer.
Through the use of Fast Ethernet ports, connect the Router to the Server. Address range 192.168.1.100/24 must be configured on the server. Launch the Server properties dialogue box, then pick the Services tab from the menu that appears. Next, choose SYSLOG from the list of options on the left, and then make sure that the On switch is selected for the SYSLOG service.
Make sure that Syslog is turned on in Cisco Packet Tracer.
Configuring the Syslog Server with Cisco Packet Tracer: Step-by-Step Instructions
After you have finished the steps in the previous section, you may go on to configuring Syslog Server. In order to do this, you will need to carry out the following steps:
To setup the proper IP address on the Router, perform the following instructions in the right order.
Router configuration number fa0/0 interface
Add 192.168.1.1 and 255.255.255.0 to the router's config file under the if#ip directive.
#no shutdown on the router (config-if), please
Next, indicate the address of the Syslog server on the Cisco router by entering the logging host followed by the syslog server IP address command.
Host 192.168.1.100 is logged in on the router (config)
Next, define the log types & category by executing the logging trap severity level> command (called severity level). Make advantage of the error log, for instance (severity level 7). You are free to utilise any other degree of seriousness that you may like to test.
#recording the router configuration in trap 7
The next step is to enable debugging for a protocol by using the debug ip protocol> command. In this particular instance, we shall make advantage of the ICMP protocol.
#debug IP ICMP on the Router
After that, use the command "ping 192.168.1.100" to produce some ICMP packets and see how well your setup is working.
Router#ping...
SOLUTION.PDF

Answer To This Question Is Available To Download

Related Questions & Answers

More Questions »

Submit New Assignment

Copy and Paste Your Assignment Here