(Cisco Packet Tracer) Requirements A.Configure PCs host IP settingsB.Configure the basic router 1.Prevent the router from attempting to translate incorrectly entered commands2.Configure host...

(Cisco Packet Tracer) Requirements A.Configure PCs host IP settings B.Configure the basic router 1.Prevent the router from attempting to translate incorrectly entered commands 2.Configure host names as shown in the topology. 3.Configure interface IP addresses . 4.set ciscoprv as the privilege password and ciscocon as the console passwords . 5. Vty lines accept Telnet connection only. Set ciscovty as the password for these lines. 6.Test vty connection using a telnet command and make any required setting to complete this connection. C.Configure the switches: 1.The initial settings: -Configure host names as shown in the topology. -Banner that includes the word warning -Console port login and password cPass -Encrypted enable password of pPass -Encrypt plain text passwords -Management interface addressing 2.Configure SSH to secure remote access with the following settings: -RSA key-pair parameters to support SSH version 2 -Set SSH version 2 -VTY lines only accept SSH connections and use local login for authentication -Test this secure connection and make any required setting to complete this connection. Note : To configure the above topology , use valid IPs of the private address ranges.

Extracted text: f0/2 f0/1 g0/0 fo/8 90/0 fo/9. 2960-24TT 2960-24TT N1-S1 PC-PT PC-PT 1941 N2-S1 BR PCO PC1