A B D (a) If the gap, w, must be at least 0.015 in for the proper functioning of the assembly, what is the correct nominal dimension for d? (b) Under the assumptions of the preceding question, what...

Extracted text: A B D (a) If the gap, w, must be at least 0.015 in for the proper functioning of the assembly, what is the correct nominal dimension for d? (b) Under the assumptions of the preceding question, what would be the most likely value for the gap, w? Would it be 0.015 in?


Extracted text: 7. This problem relates to tolerance stack-up using the absolute tolerance system, as explained in section 1-14. In the figure below, specified dimensions are as follows (all units in inches): a d 1.750 + 0.001 2.000 + 0.003 3.200 + 0.005 ?+0.010