1. Which of the following commands enables an OSPFv3 process? (A) router ospf 5 (B) ospf 5 (C) ipv6 ospf 5 (D) ipv6 router ospf 5 2. Which of the following commands would you use to change the router...

1. Which of the following commands enables an OSPFv3 process? (A) router ospf 5 (B) ospf 5 (C) ipv6 ospf 5 (D) ipv6 router ospf 5

2. Which of the following commands would you use to change the router ID of an OSPF router? (A) Use the following: Router rip Router-id 8.8.8.8 (B) Use the following: Router config Router-id 8.8.8.8 (C) Use the following: Router ospf 1 Set Router id 8.8.8.8 (D) Use the following: Router ospf 1 Router-id 8.8.8.8

3. Bob calls complaining that he cannot access the network. When you look at the switch, you notice the port he is connected to is displaying an amber light. What does this mean? (A) The IP address on the switch is incorrect. (B) The default gateway setting on the switch is incorrect. (C) The default gateway setting on Bob’s station is incorrect. (D) The port has been disabled.