1. Which of the following commands can you use to figure out the IP address of a neighboring router? (A) show cdp neighbors (B) show cdp neighbors detail (C) show cdp (D) cdp run 2. protocol being...

1. Which of the following commands can you use to figure out the IP address of a neighboring router? (A) show cdp neighbors (B) show cdp neighbors detail (C) show cdp (D) cdp run

2. protocol being used by the serial port? (A) CDP (B) PPP (C) STP (D) HDLC

3. Looking at the output in the figure below, what end of the point-to-point link is Serial0/2/0? (A) DCE (B) DTE (C) MPC8600 (D) PowerQUICC

4. If an interface shows as administratively down, what command do you use to bring the interface up? (A) up (B) enable (C) no shutdown (D) no down