1. What command would you use first to configure a setting on multiple ports on the switch? (A) Use the speed command (B) Use the duplex command (C) Use select ports command (D) Use the interface...

1. What command would you use first to configure a setting on multiple ports on the switch? (A) Use the speed command (B) Use the duplex command (C) Use select ports command (D) Use the interface range command

2. What command shows you MAC addresses associated with each port on the switch? (A) show vlan (B) show port-security addresses (C) display mac-address-table (D) show mac-address-table 399. Looking at the figure below, what is the duplex setting of the port set to? (A) Full duplex (B) Half duplex (C) Simplex (D) No duplex